Throttle Body Adapter Ford DBW to 70mm Cable
|
Little known fact: the 98-04 Ford Econoline / E Series vans had a 70mm throttle body right out of the box. It's a nice cast aluminum unit, it's compact, looks good and they are available at any junkyard for $20. If your OEM Duratec DBW throttle body isnt cutting it, this could be your solution. We modelled this for use with any common 92mm bolt circle DBW Flange intake manifold, such as the NC Miata and aftermarket intake manifolds meant for RWD 2.5 Duratec, often found in race cars, kit cars and NC miatas. Units from OneGoal, DeepMotor and Fab9 are all possibilites. Will bolt to common OEM manifolds (including FWD) as well, but those would need to be port matched. Ford 70mm TB does NOT use the same TPS plug as your factory fwd ford or mazda TPS. No IAC provisions, the stock ford TB uses either a remote mount IAC or simply uses the screw on the TB to hold it open just a bit at the closed position. Includes all stainless hardware and TB gasket. Constructed of billet 6061 aluminum and anodized signature purple for good looks and corrosion protection!!! Fits in all 4 clockings to maximize fitment options. Due to the large amount of possible engine swap combinations this can be used for, we do not include any type of throttle cable bracket with the kit. keep that in mind when doing your swap. * manifold and throttle body shown not included. TB part numbers: 3Z2Z9E926AA, F81Z9E926AA, F81Z9E926BA, YC2Z9E926BA, YC3Z9E926AA |